ESR Meter - The Capabilities To Check Beyond Electrolytic Capacitor

There is something good about esr meter because besides electrolytic capacitor it can be use to measure other type of capacitors such as the non polarity capacitor. From esr meter specification, it is usually mentioned only checking the electrolytic type. When i began to experiment with the Dick Smith ESR Meter i found that it have the capabilities to check other type of capacitors as well.

However it is limited to checking capacitor in the higher value only such as .1uf(104), .22uf(224), 1uf(105) and etc. Lower capacitance value don't get any reading from the esr meter due to it can only read until 99 ohms. Perhaps other esr meter such as the B & K esr meter have the range to check it.

You will even be surprised to see that the dick smith esr meter can check the non-polarity capacitor in-circuit (without removing the cap).

True case example-Monitor came in with display jumping horizontally. You can see a bunch of horizontal black lines across the top display (picture). From experienced it will tell you that vertical section have problem. I begin to troubleshoot the vertical section. Supply voltage checked ok, vertical driver and oscillator IC replaced, all components connected or nearby vertical driver and oscillator ic have been checked ok. By the way I used digital capacitance meter to check the non-polarity cap and esr meter to check the electrolytic cap. The problem is still there and can't be solve!

When i use Dick Smith ESR Meter to compare the esr value of a non-polarity capacitor located near the vertical driver ic, i noticed that there is a big different in the esr value. The good esr value for a .22uf non-polarity cap is between 6.5 to 7 ohm but the spoilt one have a value of 14 ohm! Almost double the value, that's why the display jump. The good thing is i discovered the culprit while the capacitor still in the circuit which mean this esr meter can check non-polarity cap in-circuit. However my recommendation for you is to solder out one leg and check unless you already have the experienced in checking components on board. Replacing the cap solved the display problem.

Conclusion-In order to accurately test a non-polarity capacitor, besides checking the capacitance value and using analog meter to check the charge and discharge to see if it has develop any short circuit when under load, you are also required to check the esr value as well.

Jestine Yong is a electronic repairer and a writer. For more information about electronic repair please visit his website at http://www.noahtec.com/electronic-repai r-articles.htm

HIPPA Goes Mobile and Wireless for Hospitals and First Responders

It appears we need to further streamline health care and... Read More

Expansion Cards Part 3: PCI Express

In the first two installments of this series of Tech... Read More

Printers: What Really Happens When You Hit ?Print?

You just poured hours upon hours into a lengthy research... Read More

Refurbished Laptop Batteries

There are three refurbished laptop battery types, each named for... Read More

How to Avoid Getting Ripped-Off When You Purchase A New Printer

It's no big secret that printer companies like HP and... Read More

Coping with a Serious Data Loss from your Computer Hard Drive

Data loss is an expensive reality. It's a hard fact... Read More

When Good Color Goes Bad...

Even with the popularity of digital technology, and the availability... Read More

Motherboard Basics

A recent Tech Tip covered the basics of selecting a... Read More

Expansion Cards Part 1: (of a 3 part series)

PCIThe expansion slots available on motherboards allow for a variety... Read More

Best DVDs for Your Personal DVD Player

When bought personal DVD player, the very next thing to... Read More